Hat Creek Construction & Materials, Inc. (HCCMI) is seeking quotes from all qualified subcontractors/suppliers including but not limited to DBE for the following items of work: LEAD COMPLIANCE PLAN, TIME-RELATED OVERHEAD (LS), DISPUTE RESOLUTION BOARD ON-SITE MEETING, HOURLY OFF-SITE DISPUTE-RESOLUTION-BOARD-RELATED TASKS, DEVELOP WATER SUPPLY, CONSTRUCTION AREA SIGNS, TRAFFIC CONTROL SYSTEM, STATIONARY IMPACT ATTENUATOR VEHICLE, PORTABLE RADAR SPEED FEEDBACK SIGN SYSTEMS (LS), PORTABLE CHANGEABLE MESSAGE SIGN (LS), AUTOMATED FLAGGER ASSISTANCE DEVICE, JOB SITE MANAGEMENT, STORMWATER POLLUTION PREVENTION PLAN, STORM WATER SAMPLING AND ANALYSIS DAY, STORM WATER ANNUAL REPORT, MOVE-IN/MOVE-OUT (TEMPORARY EROSION CONTROL), TEMPORARY COVER, TEMPORARY CHECK DAM, TEMPORARY DRAINAGE INLET PROTECTION, TEMPORARY FIBER ROLL, TEMPORARY GRAVEL BAG BERM, TEMPORARY CONSTRUCTION ENTRANCE, STREET SWEEPING, TEMPORARY CONCRETE WASHOUT, WATER QUALITY SAMPLING AND ANALYSIS DAY, WATER QUALITY MONITORING REPORT, WATER QUALITY ANNUAL REPORT, TEMPORARY CREEK DIVERSION SYSTEMS, TREATED WOOD WASTE, CONTRACTOR-SUPPLIED BIOLOGIST (DAY), INVASIVE SPECIES CONTROL, REMOVE CONCRETE (CY), CLEARING AND GRUBBING (LS), ROADWAY EXCAVATION, SHOULDER BACKING, SUBGRADE ENHANCEMENT GEOTEXTILE - CLASS A1, FIBER REINFORCED MATRIX (SQFT), ROLLED EROSION CONTROL PRODUCT (NETTING) (TYPE B), FINISHING ROADWAY, CLASS 2 AGGREGATE BASE (CY), HOT MIX ASPHALT (TYPE A), PLACE HOT MIX ASPHALT DIKE (TYPE A), PLACE HOT MIX ASPHALT (MISCELLANEOUS AREA), TACK COAT, COLD PLANE ASPHALT CONCRETE PAVEMENT, 4' X 3' PRECAST REINFORCED CONCRETE BOX CULVERT, 6' X 5'8" PRECAST REINFORCED CONCRETE BOX CULVERT, STRUCTURAL CONCRETE HEADWALL, STRUCTURAL CONCRETE DRAINAGE INLET, STRUCTURAL CONCRETE WINGWALL, BAR REINFORCING STEEL, FILTER FABRIC (CLASS D) 24" CORRUGATED STEEL PIPE (.109" THICK), 54" CORRUGATED STEEL PIPE (.138" THICK), 57" X 38" CORRUGATED STEEL PIPE ARCH (.138" THICK), 8" PERFORATED PLASTIC PIPE UNDERDRAIN, 9" NON-PERFORATED PLASTIC PIPE UNDERDRAIN, CLASS 1 PERMEABLE MATERIAL (BLANKET), 24" ANCHOR ASSEMBLY, 24" CORRUGATED STEEL PIPE TEE ENERGY DISSIPATOR (.138" THICK), 24" STEEL FLARED END SECTION, ABANDON CULVERT (LF), REMOVE CULVERT (LF), REMOVE INLET, REMOVE HEADWALL, CLEANING, INSPECTING AND PREPARING CULVERT (LF), CONCRETE INVERT PAVING, SAND BACKFILL, ROCK SLOPE PROTECTION (150LB, CLASS III, METHOD B) (CY), ROCK SLOPE PROTECTION (60LB, CLASS II, METHOD B) (CY), ROCK SLOPE PROTECTION (20LC, CLASS I, METHOD B) (CY), ROCK SLOPE PROTECTION FABRIC (CLASS 8), MINOR CONCRETE (MISCELLANEOUS CONSTRUCTION), CAST IRON RING AND LID WITH GASKET, MISCELLANEOUS IRON AND STEEL, REMOVE FENCE, RELOCATE FENCE, DELINEATOR (CLASS 2), MILEPOST MARKER, UNDERDRAIN MARKER, MARKER (CULVERT), TREATMENT BEST MANAGEMENT PRACTICE MARKER, ONJECT MARKER (TYPE L-1), REMOVE ROADSIDE SIGN (WOOD POST), REMOVE ROADSIDE SIGN (STEEL POST), FURNISH SINGLE SHEET ALUMINUM SIGN (0.080" - UNFRAMED), FURNISH SINGLE SHEET ALUMINUM SIGN (0.063" - FRAMED), ROADSIDE SIGN - ONE POST, ROADSIDE SIGN - TWO POST, RECONSTRUCT TURNABLE ROADSIDE SIGN, MIDWEST GUARDRAIL SYSTEM (STEEL POST), VEGETATION CONTROL (MINOR CONCRETE), CABLE RAILING, END ANCHOR ASSEMBLY (TYPE-SFT-M), ALTERNATIVE IN-LINE TERMINAL TL-3, THERMOPLASTIC PAVEMENT MARKING (ENHANCED WET NIGHT VISIBILITY), 12" RUMBLE STRIP (ASPHALT CONCRETE PAVEMENT), 6" THERMOPLASTIC TRAFFIC STRIPE (ENHANCED WET NIGHT VISIBILITY) (RECESSED), 6" THERMOPLASTIC TRAFFIC STRIPE (ENHANCED WET NIGHT VISIBILITY) (RECESSED, BROKEN 12-3), 6" THERMOPLASTIC TRAFFIC STRIPE (ENHANCED WET NIGHT VISIBILITY) (RECESSED, BROKEN 18-12), THERMOPLASTIC PAVEMENT MARKING (ENHANCED WET NIGHT VISIBILITY) (RECESSED), MAINTAINING EXISTING TRAFFIC MANAGEMENT SYSTEM ELEMENTS DURING CONSTRUCTION, LIGHTING SYSTEM, MOBILIZATION.

HCCMI is an equal opportunity employer and is willing to work with all qualified firms interested on this project. Subcontractors must possess a current contractor’s license, current PWCR, insurance coverage and worker’s compensation for the entire length of the contract. Firms are also required to comply with all In Use Off Road Diesel Vehicle regulations. If qualified firms need assistance in obtaining project plans, specifications, or requirements please contact estimating@hatcreekconstruction.com or our office at (530) 355-5501 or can also be viewed at 24339 State Highway 89 North, Burney, CA 96013. All subcontractors will be required to sign our standard Subcontract Agreement. 100% payment and performance bond may be required. Please call if you need assistance obtaining insurance, bonding, equipment, materials, and/or supplies. HCCMI intends to work cooperatively with all qualified firms seeking work on this project. We will work with any interested subcontractor/supplier to identify opportunities to break items into economically feasible packages. All DBE firms must be certified by bid date.